PLC programming involves both direct and indirect addressing. Direct address programming involves writing each ladder logic rung to do the operation required. We often forget about using the powerful indirect addressing to solve our logic.
The below animated picture will show a simple example of using indirect addressing. This will use the MOVE instruction and transfer a word indirectly to output word V100. V[V0] means that the value in V0 will point to the V memory to get the value to move. You can think of this as a pointer for the memory location to move.
Of course we need to monitor V0. Our values are in sequence from V1 to V6. We need to ensure that V0 is always in the range from 1 to 6.
Lets take a look at a program sample using the Do-more Designer Software. We will set up the sequence similar to the animation above, but expand the program.
Just like above we will set up the pointer at V0 and the output at V100 memory locations. V1 to V37 will hold our output data sequence. This is outputs that we want to set on each event and/or time frame. You can see some of the registers and the corresponding values. These are set as a hexadecimal value. The following link will provide a review of the numbering systems in the PLC. (WHAT EVERYBODY OUGHT TO KNOW ABOUT PLC (PROGRAMMABLE LOGIC CONTROLLER) NUMBERING SYSTEMS)
This is the logic to set up the move instruction. The source is V[V0] which means the pointer is V0 in this memory area. The destination will be V100.
An internal timing bit ST5($100ms) is used to increment the pointer V0. This could also be done by an event or series of events. The pointer is then compared to ensure that it is between 1 and 37.
Finally the output word is then transferred to the physical outputs. This is done by using the MAPIO instruction. Each bit can be set independently.
This example uses indirect addressing to program a sequence based upon time. We could just as easily used indirect addressing to compare inputs to a table and set the outputs accordingly. You can see how this method can greatly reduce the amount of time to develop your program. This holds especially true if the sequence needs to be changed. It would be just a matter of changing data values in the table.
The following are separate posts that use indirect addressing:
If you have any questions or need further information please contact me.
If you’re like most of my readers, you’re committed to learning about technology. Numbering systems used in PLC’s are not difficult to learn and understand. We will walk through the numbering systems used in PLCs. This includes Bits, Decimal, Hexadecimal, ASCII and Floating Point.
To get this free article, subscribe to my free email newsletter.
Use the information to inform other people how numbering systems work. Sign up now.
The ‘Robust Data Logging for Free’ eBook is also available as a free download. The link is included when you subscribe to ACC Automation.