Omron CP1H PLC Establish Communication

We will now establish Omron cp1h communication using the built-in USB connection. CX-Programmer will be used to communicate. The Omron CP1H series of programmable logic controllers are programmed from CX-Programmer. CX-Programmer is part of the Omron CX-One Factory Automation Integrated Tool Package. We will now establish communication with our CP1H PLC using CX-Programmer. We will be using the USB connection (Built into the CPU) as well as an RS485 connection using the CP1W-CIF11 module. The Start-Stop and Jog circuit that we developed last time will be transferred to the PLC unit. We will then verify that the program in the PLC is the same as the program logic in CX-Programmer. More information can be obtained on our website. This includes all of the links mentioned in this video. https://accautomation.ca/omron-cp1h-establish-communication/ 00:00 Omron CP1H Programming Communication 00:35 Hardware - USB and RS485 communication to Omron CPU 01:43 RS485 to USB Converter 02:30 Serial RS485 (Similar to RS232) Establish Communication 06:15 Transfer program to Omron PLC 08:08 Verify program in PLC 09:10 USB port to Omron programming software The purpose of this Omron CP1H Series is to get you familiar with this programmable logic controller. (PLC) Previously in this Omron CP1H series, we looked at the following: System Hardware http://accautomation.ca/omron-cp1h-system-hardware/ CX-Programmer http://accautomation.ca/omron-cp1h-cx-programmer/ There are several reasons why we are using the Omron CP1H Controller. Here are just a few. - Standalone PLC with built-in I/O - Communication ability - Ethernet Port, RS232, RS485 - support for protocols such as Modbus, Host Link, ASCII (No Protocol) - Built-in Analog inputs and outputs - 4 axis control of motion - 4 high-speed counters - powerful instruction set (similar to CS and CJ series) - Ability to expand the system with a variety of modules The Omron CP1 series of programmable logic controllers consists of three different units. CP1E is the cost-effective unit, CP1L is the high performing controller that can come with embedded Ethernet and the CP1H is the position control and comprehensive programmable logic controller. We will be looking a the CP1H for this series, but a majority of the information can be applied to the CP1E and the CP1L controllers as well. https://www.accautomation.ca