Click PLC Stop the Timer at the Set Value

Click PLC stop the timer at the Set Value (SV) When the Click PLC timer reaches the set value the timer output bit is turned on. However, the present value of the timer continues to increase until the timer is reset. This is generally not a problem unless you are displaying this on an external device like an HMI. (Human Machine Interface) To stop the Click PLC timer at the set value, use the output bit to copy the set value into the present value. In this example when the T1 output bit turns on then the value of 3000 (3 seconds) is copied to the TD1 address. This will hold the timer at the set value. Programming and examples of the Click and Click PLUS PLC series can be found at this URL: https://accautomation.ca/series/click-plc/ https://accautomation.ca/click-plc-timers-and-counters/ There are several reasons why we are using the Click and Click PLUS PLCs. Here are just a few. - Investment is low for the hardware and the software is free - Standalone PLC with built-in I/O - Communication ability - Ethernet Port, RS232, RS485 - support for protocols such as Modbus RTU, Modbus TCP, etc. - Ability to expand the system with a variety of modules including RTD and Thermocouple inputs directly. General information on the Click series of controllers: www.clickplcs.com/config