Modbus RTU Click PLC Master to BRX Do-More PLC Slave Communication

We will now use Modbus RTU to connect a Click Master to a BRX Do-More Slave controller. Recently I was asked to demonstrate communication between a Click PLC and BRX PLC using Modbus RTU. Both PLCs are available from automation direct com. Modbus serial communication (Modbus RTU) is a standard protocol used in many automation devices. It works on a Master / Slave configuration. You can have only one master per network on Modbus RTU (Remote Terminal Unit). A maximum of 32 devices (Nodes) on the network can communicate to the master. A review of the Modbus RTU protocol (RTU frames) can be seen at the following URL. http://www.rtaautomation.com/technologies/modbus-rtu/ Using the Click PLC as a Master we will be communicating to the BRX PLC (Slave). Our example will read 10 registers from the BRX PLC and write 10 registers to the Click PLC. Let's get started! More information can be obtained at our website. This includes all of the links mentioned in this video. https://accautomation.ca/modbus-rtu-click-plc-master-to-brx-plc-slave-communication 00:00 Modbus RTU Click PLC Master to BRX Do-More PLC Slave Communication 01:28 Wiring – Modbus RTU 02:11BRX Do-More PLC Configuration 03:10 BRX Do-More Ladder Program 04:14 Click PLC Configuration 05:03 Click PLC Program 07:33 Running and monitoring the communication Previously we discussed: Click PLC System-Hardware. https://accautomation.ca/click-plc-system-hardware/ Click PLC Installing the Software https://accautomation.ca/click-plc-installing-the-software/