Category Archives: Safety Controller

ACC Automation 2019 Review

Accelerate Learning …
Accelerate Machines…
Accelerate Knowledge…
ACC Automation

It is a good time to be in the automation business. Technologies are merging and communicating like never before. What was impossible is now possible for the industrial plant floor. We are looking forward to the New Year and new possibilities for implementing your control solution.
Each year we like to take a few minutes and reflect on the past, current, and future of ACC Automation. You have helped us to build the site that you see today through questions, comments, and suggestions. Thank you.
2019 has been our best year yet thanks to you. Keep on Reading!

MOSAIC Safety Controller Emergency Stop

The MOSAIC Modular Safety Integrated Controller can be programmed for your safety control application. Steps to programming our MOSAIC include writing the program, verification, simulation, downloading and monitoring. We will be looking at the E-STOP instruction part of our program.
MOSAIC Safety Controller Emergency Stop
Our first program included writing, verifying, simulating and monitoring our MOSAIC Safety emergency stop switch and status indication. (feedback) We will now modify our E-STOP in our circuit and discuss redundancy, short circuit protection, and manual reset. Let’s get started. Continue Reading!

MOSAIC Safety Controller Reports / Documentation

The MOSAIC Modular Safety Integrated Controller can be programmed for your safety control application. Steps to programming our MOSAIC include writing the program, verification, simulation, downloading and monitoring. Documentation has been included in this controller software that will save you hundreds of hours.
MOSAIC Safety Controller Reports / Documentation
Our first program included writing, verifying, simulating and monitoring our MOSAIC Safety emergency stop switch and status indication. We will now look at the reports and documentation that we can obtain by our Mosaic Safety Designer software (MSD). We will also look at ways that we can verify our existing program. Let’s get started. Continue Reading!

MOSAIC Safety Controller First Program Part 2

The MOSAIC Modular Safety Integrated Controller can be programmed for your safety control application. Steps to programming our MOSAIC include writing the program, verification, simulation, downloading and monitoring.
MOSAIC Safety Controller First Program Part 2
In part 1, we wrote, verified and simulated our program. Our first program has an emergency stop switch with status indication. We will now be using the MOSAIC Safety Designer software (MSD) to download and monitor our program. The wiring and indication lights on our MOSAIC M1 safety controller will also be discussed. Let’s get started. Continue Reading!

MOSAIC Safety Controller First Program Part 1

The MOSAIC Modular Safety Integrated Controller can be programmed for your safety control application. Steps to programming our MOSAIC include writing the program, verification, simulation, downloading, and monitoring.
MOSAIC Safety Controller First Program Part 1
We will be using the MOSAIC Safety Designer software (MSD) to write, verify, and simulate our program. Our first program will have an emergency stop switch with a status indication. Let’s get started. Continue Reading!