HMI

Horner XL4 Cscape Software Setup – All In One

by

The Horner XL4 OCS all-in-one controller is programmed using Cscape. Cscape (Control Station Central Application Programming Environment) We will now set up the Cscape software so we can easily communicate and program our controller.

Horner XL4 Installing the Software Cscape

by

The Horner XL4 OCS all-in-one controller is programmed using Csape. Cscape (Control Station Central Application Programming Environment) This single programming software package is designed to be easy to use and maintain. We will now install this programming package onto our computer.

Horner XL4 System Hardware – All In One

by

The Horner XL4 OCS is an All-in-one controller. This means that this modern unit combines a logic controller, operator interface, I/O and networking all into one package. This OCS (Operator Control Station) family was first released in 1998. New features to the line-up have been added over the years. Today the OCS family has a … Read more

Deploying an AdvancedHMI Project – Installation

by

Deploying an AdvancedHMI project on the industrial floor sounds like an easy task, but there are a few things that you should consider. The HMI (Human Machine Interface) user interface will run on a computer. The industrial environment is one in which temperature, dust, electrical noise, etc. are always present. This can also be combined … Read more

AdvancedHMI to Solo Temperature Controller

by

Modbus RTU will be the serial (RS485) method in which we will communicate between the AdvancedHMI Screen and the Automation Direct Solo Process Temperature Controller. We can address up to 247 (Solo 1 to 247) devices on this master-slave protocol. A maximum of 32 devices (Nodes) on the network can communicate to the master. A … Read more