Tag Archives: wiring inputs

Wiring a Capacitive Proximity NPN PNP Sensor to the Click PLC

A proximity sensor (switch) is able to detect object presence without physical contact like a limit switch. No physical contact means that the switch has no parts that will wear out. The life span of the sensor is increased with less maintenance.
A capacitive proximity sensor will detect ferrous and non-ferrous objects. The sensor works by oscillating the charge on the plates in the sensor. When an object is placed in front of the surface, the amount of current flow is detected. (Capacitance) The dielectric of objects will determine the distance that the object can be detected.

We will be wiring a capacitive proximity switch into the input of our Click PLC. The CK1-00-2H is an 18mm diameter, NPN/PNP N.O./N.C. selectable output with a 12mm sensing distance. That means that the sensor can be wired as positive (Sourcing) or negative (Sinking) switch. This unshielded 10 Hz switching frequency sensor also has a 4-pin M12 quick disconnect. Let’s get started. Continue Reading!

Wiring an Inductive Proximity NPN PNP Sensor to the Click PLC

A proximity sensor (switch) is able to detect object presence without physical contact like a limit switch. No physical contact means that the switch has no parts that will wear out. The life span of the sensor is increased with less maintenance.
An inductive proximity sensor will detect ferrous metals. The sensor develops an electric field when metal (sensing object) is introduced usually killing the oscillation circuit of the sensor triggering the output.

We will be wiring an inductive proximity switch into the input of our Click PLC. The AM1-A0-4A is an extended range 12mm tubular sensor that can be wired into the PLC as a sink or source input. Let’s get started. Continue Reading!

Wiring Push Buttons and Selector Switch to Click PLC

A push button (pushbutton) is a simple human interface for controlling some aspect of a machine or process. The push button requires a force to push the button to change the electrical operation from off to on or vice versa. The condition of the output is usually momentarily. Some common everyday pushbuttons we use are keyboards keys.

A selector switch is also a mechanical device that will require a force to turn the electrical operation from off to on or vice versa. The selector switch usually locks into a position.

We will be wiring two illuminated pushbutton switches into our Click PLC. A selector switch will also be wired in. Let’s get started. Continue Reading!

Create an Analog Voltage Input Tester for a PLC

We will create a simple and inexpensive analog voltage tester for a PLC using a potentiometer and a 9VDC battery. The potentiometer will be 5K ohms. This should be enough impedance for most analog inputs of the programmable logic controller. (PLC) Voltage impedance for analog voltage inputs are in the mega ohm range where current input is typically 250 ohms. Our tester will be for analog voltage inputs (0-10 VDC). Check your input specifications before wiring anything to your PLC. I have used this tester for other voltage inputs along with a meter to ensure that the voltage levels do not get out of range for the input signal.
Analog inputs to the PLC are continuous and can come in a variety of signals. These signals can come from temperature, flow rate, pressure, distance, etc. Continue Reading!