ACC Automation: PLC & Industrial Control Learning
Practical Tips and Techniques
The Ethernet Click PLC high-speed counter has seven different modes of operation. In Part 1 we discussed the High Speed Count Mode, Interval Measurement Mode, Duration Measurement Mode and Frequency Measurement Mode. This 100 kHz counter can accept Up, Down, Up/Down, Pulse/Direction, or Quadrature (with Z) inputs. We will be looking at the last three … Read more
The Click PLC family has been updated, and now has the ability to use high speed counting. This is available on all of the Ethernet units that have DC inputs. The faster processor on the Ethernet unit (3 to 10 times faster than the basic unit) allows this capability. There are seven (7) different modes … Read more
We will now look at the programming and wiring of a rotary encoder to the Click PLC input. Rotary encoders are modern digital devices that have taken over from the potentiometer in stereos and many other applications. This is because of their fine digital control, and they can fully rotate without end stops. We can … Read more
Firmware is usually PLC operating system code that is written into a read only memory. The BIOS (Basic Input Output System) of a PC (personal computer) is a good example of firmware. It provides the low level interface between the hardware and software. The Click PLC firmware comes with the programming software. https://support.automationdirect.com/products/clickplcs.html We will … Read more
The Productivity 1000 series of programmable logic controllers has a slim stackable super compact design. This is sometimes also referred to as a shoebox PLC because of the shape and way in which expansion modules are added. This new Productivity 1000 series PLC is the latest in the Productivity series of controllers that have hit … Read more
We will now use Modbus RTU to connect a Click Master to a BRX Do-More Slave controller. Recently I was asked to demonstrate communication between a Click PLC and BRX Do-More PLC using Modbus RTU. Both PLCs are available from automation direct com. Modbus serial communication (Modbus RTU) is a standard protocol used in many … Read more
The data control instructions in the Omron CP1H programmable logic controller are used to manipulate the outputs based upon control conditions. Control is the main purpose of these instructions within the PLC. Instructions include PID (Proportional, Integral, and Derivative), PID with Autotuning, Dead Band Control, Limit, Dead Zone Control, Time Proportional Output, Scaling, etc. We … Read more
The Omron CP1H programmable logic controller has several different table data processing instructions. These instructions are used to handle table data, stacks and other ranges of data. We can define a stack of data. With this data we can then do the following: add new data by pushing onto the stack, use FIFO (First In … Read more
The Omron CP1H programmable logic controller has several different ways to control the program and the way in which your program executes. Sequence control, Subroutines, and Step instructions can be used. These are just a few ways in which the controller will execute your logic using a synchronous PLC scan. Understanding the PLC program scan … Read more
We will now look at data conversion instructions in the Omron Cp1H Controller. Programmable logic controller programming is all about manipulating the bits within the memory of the controller. Sometimes we need to convert from one form to another. This is where we will use data conversion instructions. BCD to Binary, Line to Column, Grey … Read more