We would like to take a few minutes and reflect on the past, current and future of ACC Automation. 2017 has been our best year yet thanks to you. Your questions, comments and suggestions have helped us to build the site that you see today.
Thank you. Continue Reading!
Serial communication instructions will allow you to send and receive serial data to an external device. The communication method that you setup can be ASCII or numeric (binary). ASCII (American Standard Communication for Information Interchange) can be used to send to devices such as a printer or display.
Receiving ASCII can be used for connecting barcode scanners to the PLC. The barcode will be read as an ASCII string in the PLC.
The BRX Series PLC will allow you to use instructions such as STREAMIN and STREAMOUT to send and receive data from devices mentioned above. They are usually a one to one device and do not have a protocol.
A protocol is like a language used to communicate to different devices connected together. Modbus serial communication (Modbus RTU) is a standard protocol used in many industrial automation devices. The BRX Series PLC has a MRX (Modbus Network Read) and MWX (Modbus Network Write) instructions.
We will demonstrate these instructions by communicating Modbus RTU to a Solo Temperature Controller. (RS485) Our example will read the current process (PV) value and write the set point value (SV) in the controller. Let’s get started. Continue Reading!
Drum instructions are great tools when you have a simple sequence of events that need to occur at a set time interval or as a result of an event. They mimic an electromagnetically drum sequencer. The BRX Series PLC has a drum in the instruction set.
Have you ever seen the mechanisms of a music box? Ok so it’s a little drum with pegs that catch and flick the chimes in a particular sequence to play whatever tune is on the drum. So in the PLC you can have a drum driven by an event, (input from a limit switch or button), or by time.
We will discuss the drum instruction and look at an example of controlling traffic lights with a cross walk signal. Continue Reading!
We will now look at another way of programming our palletizer using the PLC. How many ways can you program the PLC for the same function? The answer is a lot of different ways. You can have ten different programmers working on the same program and get ten different automatic control PLC programs. Sure they may have similarities but, they are all unique in their code within the PLC. As a system integrator, you will see many different ways of programming the PLC. We will now look at reprogramming our palletizer example using drum instructions. (Sequencer)
Last time we applied the five steps to PLC program development to a palletizer example. We will review our steps and then change our programming code to incorporate the drum instructions. Like our original example, we will allow the operator to change the layers of boxes you want on each skid. We will also add in this example a manual operation sequence to cycle through each of the steps for troubleshooting the program.
Developing the PLC program is a process that can be clearly defined. In our series on the five steps to PLC program development, we have done some similar practical examples.
PLC Programming Examples – Five Steps to PLC Program Development – Press
– Process Mixer
– Shift Register (Conveyor Reject)
– Paint Spraying
– Delay Starting of 7 Motors – Pick and Place
– Sorting Station (Shift Register)
Define the task: (1) – PLC Programming Example Palletizer using Drum