PLC inputs are one component of our PLC block diagram. The output actions of the PLC will be controlled based on the inputs. We will be looking at digital and analog inputs that can be wired to the programmable logic controller.
We will be looking at wiring of a normally open (NO) push button, normally closed (NC) push button, 3 wire PNP sensor, and an analog sensor to the PLC. These will all be sinking inputs. Let’s get started. Keep on Reading!
We will now look at the tilt ball switch on our Arduino Uno super starter kit. Tilt sensors (tilt ball switch) allow you to detect orientation or inclination. They are small, inexpensive, low-power, and easy to use. Their simplicity makes them popular for toys, gadgets, and appliances. Tilt ball switches are sometimes referred to as “mercury switches”, “tilt switches”, or “rolling ball sensors”.
We will be wiring a tilt ball switch to our Arduino UNO R3 controller on our super starter kit. Let’s get started. Continue Reading!
We will now be looking at using digital inputs (pushbuttons) to turn LEDs on and off. This will be programmed using our Arduino Uno R3 from our Super Starter Kit. Pushbuttons will allow actions to be performed that our Arduino program sketch will interpret and take action.
We will be wiring two pushbutton switches. A pull-down resistor will be wired to the first switch and a pull-up resistor will be wired to the second switch. This will change the state of the input (High (1) or Low (0)) based on the wiring. Two LEDs will be wired to the outputs of the Arduino Uno. This will show the state of the switches and allow the switch inputs to modify the state of the LED. We will look at three different programs.
Eliminating switch bouncing will also be discussed and programmed using our Arduino Uno super starter kit. Let’s get started. Continue Reading!