Practical Tips and Techniques
Wiring outputs to the plc like relays and motors.
PLC outputs are the next component of our PLC block diagram. The PLC program will control the outputs of the PLC. Controlling outputs is one way to get the inputs to change. We will be looking at digital and analog outputs that can be wired to the programmable logic controller. PLC troubleshooting outputs will also … Read more
Arduino consists of a family of single programmable circuit boards and the IDE (Integrated Development Environment) that uses a streamlined version of C++ to write and upload code to the boards. Many pre-configured circuit boards, called “shields”, are available to expand the functionality of the Arduino controller. These shields can provide Ethernet, WiFi, GPS, LCD … Read more
In part 1 we added additional discrete digital inputs and outputs modules (cards) to our P1AM-START1 (Industrial Arduino) ProductivityOpen starter kit with Ethernet. A program was then discussed that will print the modules in our system and then set and reset discrete digital inputs and outputs. P1-16TR – Productivity1000 relay output module, 16-point, 6-24 VDC/6-120 … Read more
The productivity open Arduino P1AM I/O interface chip-set supports the full suite of Productivity 1000 (P1) Inputs / Outputs expansion modules. These modules are industry approved and proven in the industrial environment. Modern industrial signal levels for digital and analog inputs and outputs are used. P1000 modules available to you include the following: • Discrete … Read more
We will now look at the P1AM Arduino expansion analog modules. This analog expansion is part of the P1000 cards that the P1AM Arduino can use as it’s inputs and outputs. The productivity open P1AM I/O interface chip-set supports the full suite of Productivity 1000 I/O expansion modules. These modules are industry approved and proven … Read more
Math instructions in your Arduino sketches (programs) consist of arithmetic operations, compound operators, absolute, power, square root, sin, cos, tan, random, map and constrain. These instructions will be generally used with other instructions in your sketch. We will be looking at each of these instructions that are available using productivity blocks. A sample program will … Read more
